Detecting network branding triggers and controlling existing graphic overlay devices.
Detecting AFD packets and controling a keyer to replace pillar bars with graphic content.

The VDD-100 provides a simple interface allowing the detection of VANC packets in a SMPTE 292/259 signal.

As a member of the openGear family, the VDD-100 shares a common control interface, known as DashBoard, with a broad array of other products.
Card configuration can be saved to a PC. This configuration can be used to reconfigure a card back to a known state or to quickly clone the card setup into other cards.

To make configuration truly easy, the VDD-100 offers a complete user interface through the DashBoard control program. It also provides a Heads-Up Display on separate monitoring outputs; both analog video and SDI are available. When activated, card status and parameters can be viewed and adjusted using the cardmounted finger joystick and an easy to use menu system.

The VDD-100 is housed in the openGear DFR-8300 series frames. It is compatible with both 10-slot and 20-slot frames.

Detection of VANC packet:

Detects up to 8 different VANC packets
Triggers GPIO outputs
Matches on DID / SDID and 1 to 20 bytes of packet
Select which bytes must match with a mask
Match on packet length or on first 'n' bytes

The VDD-100 provides remote control of:

Network branding triggers
Logo insertion equipment
Aspect ratio control

Detects presence of up to 8 packets in the VANC
Matches on packet length or on the first 1 to 20 bytes
Masks to "don't cares" any part of the match string
Signals external devices with GPIOs
SNMP capable for monitoring with 3rd-party systems

Video Standards

SMPTE 259M:
SMPTE 292M:
- 1080i: 25, 29.97, 30Hz
- 1080p: 23.98, 24Hz
- 1080sf: 23.98, 24Hz
- 720p: 50, 59.94, 60Hz
SMPTE 291M

Connectors

Connectors are located on rear panel I/O modules (sold separately)
Rear module p/n ONG-MDL-R01/R21 & ONG-MDL-R02/R22:

Video In & Out: BNC, 75 ohm, 292M, 259M, & ASI compliant, bypass relay protected
Monitor Out: BNC, 75 ohm, output monitor for test
GPIO connector (-R01, -R21): 4 terminal blocks, 8 inputs active output GPIOs
GPIO connector (-R02, -R22): two 8-pin terminal blocks, used as isolated outputs

Switches

Bypass push button
General purpose joystick controller

Indicators

Power
Video
Bypass
Status

Environment

Operating Temperature: 32 - 104º F (0 - 40º C)
Storage Temperature: -40 - 149º F (-40 - 65º C)
Humidity: 10 - 90% non-condensing

Regulatory Approvals

FCC Part 15
CE
RoHS