The TSI-100 is ideally suited for use in remote television broadcast translators to mute or power off the re-transmitter when the main broadcast goes off the air. It may also be used in a cable head-end for the same purpose.

As a member of the openGear family, the TSI-100 shares a common control interface, known as DashBoard, with a broad array of other products.
Card configuration can be uploaded to a PC. This configuration can be used to reconfigure a card back to a known state or to quickly clone the card setup into other cards.

To make configuration truly easy, the TSI-100 offers a complete user interface through the DashBoard control program.

The TSI-100 is housed in the openGear DFR-8300 series frames. It is compatible with both 10-slot and 20-slot frames.

Signals a remote device or alarm when an incorrect transport stream or no transport stream is present
Simple setup, enter the TSID of the transport stream
Two GPIOs provide both normally open and normally closed signaling
Unattended operation, set it and forget it
SNMP capable for monitoring with 3rd-party systems

Video Standards

DVB-ASI
ATSC Transport Stream

Connectors

Connectors are located on rear panel I/O modules (sold separately) - Rear module p/n ONG-MDL-R01/R21 & ONG-MDL-R02/R22:

Video In & Out: BNC, 75 ohm, 292M compliant, bypass relay protected
Monitor Out: BNC, 75 ohm, output monitor for test
GPIO connector (-R01, -R21): 4 terminal blocks, used as 8 inputs or 8 outputs
GPIO connector (-R02, -R22): two 8-pin terminal blocks, used as isolated outputs

Switches

Bypass push button

Indicators

Power
Video
Bypass
Status

Environment

Operating Temperature: 32 - 104º F (0 - 40º C)
Storage Temperature: -40 - 149º F (-40 - 65º C)
Humidity: 10 - 90% non-condensing

Regulatory Approvals

FCC Part 15
CE
RoHS